Visonic MCT-302 wireless magnetic contact
The Visonic MCT-302T is a fully supervised, PowerCode magnetic contact for electronic security equipment.
The MCT-302T includes a built-in magnet switch and an additional wired input, which can be programmed as NC or EOL, for the use of additional sensors such as push buttons, detectors, door contacts, etc. A DIP switch allows you to switch off the magnet switch. , when only the wired input is required. Although the magnetic switch and the additional input use the same RF module, they behave like separate transmitters.
The MCT-302T is protected by a tamper switch, which is activated when the top is removed, and a sabotage switch on the bottom, which is activated when the MCT-302T is pulled out by force. When the tamper switches are activated, the magnetic contact will send a tamper alarm. When you switch off the magnetic contact, the tamper alarm is sent with the ID code of the auxiliary input.
A presence alert (supervision) is automatically sent every 15 minutes by the magnetic contact, or when it is switched off, by the additional input. In this way the receiver is kept informed at intervals of the active participation of the transmitter. An LED lights up when an alarm or tamper notification is sent. The LED does not light when a supervision message is sent.
Power is obtained from a CR2, 3V Lithium battery. (included.) If the battery voltage is low, a low battery voltage message will automatically be added to each message sent